0.05KW~0.4KW Servo Motor Drive RS485 Communication Mode
Introduction to product features
Powerful internal motion control function, which can complete control modes such as position,
speed, torque and homing, and support i/o control and standard Modbus RTU The protocol can
replace PLC or pulse module in some occasions to reduce the application cost.
● Easy connection with touch screen (HMI)
Simplified control system
Save wiring
Parameter setting and status monitoring
● Rs485 motion control with PLC
PLC comes with RS485 interface
Simple control and convenient programming
Save PLC pulse output points
● Direct control via switch
Minimalist motion control scheme
Ultra low cost design
Cyclic control of point motion
● Controlled by i/o module of PLC
PLC pulse output module required
Reduce users' system design cost
Simpler control and easy operation
Parameter:
Wiring diagram of position control mode
1. The internal +24v power supply voltage range is 20v~28v, and the maximum working current is 100mA.
If an external 24V power supply is used, please connect the external power supply +24v to pin 16 (COM),
and the external power supply 0V to pin 43 (e0v).
2. The user of do output power supply needs to provide it by himself. The recommended
working powersupply voltage is DC24V, and the conduction voltage drop of do port is about 2.4V.
Please pay attention to it in application.The maximum allowable voltage of do port is DC30V
and the maximum allowable current is 50mA.
